Certified Attic Mold Removal
for Riverview Attics — Cause Before Treatment

Cold-climate zones: winter condensation from interior air infiltrating attic floor gaps. Hot-humid zones: summer outdoor air moisture infiltrating attic via inadequate ventilation. Both scenarios worsened by exhaust fan termination inside attic. Cause determines correction.

Sapstain from lumber mill organisms (typically Ophiostoma species) appears as uniform blue-black or grey-black staining flat on the wood surface — it's actually in the wood fiber from the milling and drying process, present before the panel was installed. It doesn't have visible surface texture, white or grey hyphal fringe, or fuzzy growth patterns. Active mold colonies have surface texture, may have white or grey sporulating fringe, and are associated with elevated MC% in the panel. We confirm by measuring MC% at sapstained panels — consistently low MC% (below 14%) in a dry attic confirms non-active status; elevated MC% indicates active growth associated with current moisture conditions. Lab surface sampling can confirm when visual and moisture data don't give a clear answer.

In-place treatment for structurally sound panels with surface colonization. Replacement for panels with physical delamination or decay fungi penetration. Individual panel assessment — not blanket replacement of all darkened panels.

An exhaust fan terminates inside the attic when the installer ran the flex duct from the fan housing but didn't connect it to an exterior penetration — leaving the duct end loose inside the attic, or connecting to a gap between sheathing panels. Every time the fan runs, it deposits the full moisture load from bathroom steam directly onto the attic framing and sheathing above the bathroom. For a bathroom with a 50 CFM fan running 20 minutes per shower, that's a significant daily moisture addition directly onto cold attic framing. Proper exterior termination requires insulated flex duct (to prevent condensation inside the duct), properly connected at both the fan housing and a correctly-sized exterior wall, soffit, or roof cap.

We apply treatment products only to structural wood components — sheathing and rafters — not to roofing materials. SDS sheets for all products we apply are available on request and can be provided to your roofing manufacturer representative for review. For panels requiring structural replacement that are under shingles, coordination with a roofing contractor is required — the roofing material is removed by the roofer, sheathing is replaced by our crew, and the roofing contractor reinstalls. We coordinate scheduling for panels requiring this approach.